- HOMESEER UPDATE MULTISENSOR 6 MANUAL
- HOMESEER UPDATE MULTISENSOR 6 PLUS
- HOMESEER UPDATE MULTISENSOR 6 SERIES
Parameter 5 is 1 (send Basic Set CC), the default value. I configured them with a timeout of 60 seconds, and sensitivity of 5. According to the Node Information page, their route to my Z-NET is "Direct (100K)". I just got 3 Aeotec Multisensor 6 (Model ZW100-A). With parameter 4 set to 5, which is enabled and maximum sensitivity, mine actually shows 'disabled' in the dropdown box on the settings page. I don't think the HS settings page is aware of this as it was a change introduced in a firmware revision. I would check parameter 4 (1 byte) as you can set different values for different sensitivities. Incidentally I notice on your settings page you have motion set to 'enabled'. HS detects it as a routing mode when you include it on power and that doesn't change when you remove the power so it doesn't seem a good idea. This is contrary to other advise which says the opposite.
HOMESEER UPDATE MULTISENSOR 6 MANUAL
The manual recommends including and setting it up on USB power even if you are going to ultimately run it on batteries. The manual says if you hold the button for 3 seconds it will wake up for 10 minutes but I had trouble getting that to work successfully. It needs to be woken up before HS can open the settings section and it can be quite tricky to keep it awake to do this. I was certainly able to configure settings on the one I have running on batteries. Having one powered one with batteries.Your two screen shots seem to be identical, maybe I'm missing something.
HOMESEER UPDATE MULTISENSOR 6 PLUS
Z-Wave Plus certified.About Second Quote, My Sensor wouldn't open the Menu to control parameters until I set it in Power, It was the difference I notice as I set my second one.Works with certified Z-Wave gateways and tested with Fibaro, HomeSeer, Indigo 7, openHAB, SmartThings, and Vera.Can be installed in corner, in-wall, on shelf or recessed in ceiling with Recessor accessory.
Up to 2 year battery life or power via USB.6-in-1 Z-Wave Plus MultiSensor: motion, humidity, temperature, light lux, UV, vibration sensor.
Power: DC 5V 500mA via USB cable or 2 x CR123A battery (not included) Weight: 2.6 oz. Working Humidity: 8% ~ 80% Operational site: Indoor and outdoor Light Sensor : 0 lux to 1000 lux Vibration Sensor : acts as tamper switch, ON or OFF Motion Sensor : 16 feet, and 120° field of view It has AES 128 bit security encryption built right in.
HOMESEER UPDATE MULTISENSOR 6 SERIES
It’s built around the latest Z-Wave 500 series chip and firmware, providing a 50% greater wireless range and a 250% faster communication speed over previous Z-Wave products. A part of Aeotec Gen5 range of Z-Wave products, MultiSensor 6 outperforms all that has come before it. And it can be powered 2 different ways: by batteries or via a USB cable and adapter. Only 1.65 inches in size, can be installed in your home 4 different ways: on a shelf, in a corner, within a wall cavity, or on a wall as a beam sensor. MultiSensor 6 will measure MOTION, TEMPERATURE, HUMIDITY, LIGHT LUX, UV, and VIBRATION. Designed and calibrated for precision, the accuracy of MultiSensor 6’s sensors varies as little as ☐.2%. A 6 in 1 Z-Wave Plus sensor, its perfectly small size hides the technology that powers real-time intelligence for your smart home. MultiSensor 6 is the foundation of a modern smart home.